Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 100

Status name
Message
Host machine operation after
the message is displayed
Detection timing
Detected to (location)
Alarm log storage location
*1 : The detection timing can be changed in the following service modes (setting of the Toner advance notice alarm notification
timing). The alarm can also be set to be disabled.
• COPIER > OPTION > PM-DLV-D > TONER-Y
• COPIER > OPTION > PM-DLV-D > TONER-M
• COPIER > OPTION > PM-DLV-D > TONER-C
• COPIER > OPTION > PM-DLV-D > TONER-K
*2 : Whether to display this message can be changed in the following service mode (setting of the ON/OFF of toner preparation
message).
• COPIER > OPTION > PM-PRE-M > TONER-Y
• COPIER > OPTION > PM-PRE-M > TONER-M
• COPIER > OPTION > PM-PRE-M > TONER-C
• COPIER > OPTION > PM-PRE-M > TONER-K
*3 : The detection timing can be changed in the following service modes (setting of the days left before the Toner Preparation
Warning).
• COPIER > OPTION >PM-MSG-D > TONER-Y
• COPIER > OPTION >PM-MSG-D > TONER-M
• COPIER > OPTION >PM-MSG-D > TONER-C
• COPIER > OPTION >PM-MSG-D > TONER-K
*4 : After an advance notice alarm is sent, the next advance notice alarm will not be sent until the replacement completion alarm
is sent.
*5 : The message is generated by UGW and displayed on the UGW portal screen. This is not displayed on this machine.
Alarm codes
• Toner (each color) advance notice alarm
10-0017: (Y)
10-0018: (M)
10-0019: (C)
10-0020: (Bk)
• Toner Bottle empty alarm (each color)
10-0401: (Y)
10-0402: (M)
10-0403: (C)
10-0404: (K)
• Toner low (each color) alarm (UGW-generated alarm)
10-0001: (Bk)
10-0002: (C)
10-0003: (M)
10-0004: (Y)
■ Detection of Toner Container Premature Replacement / Toner Replacement
Completion
Purpose
To detect the completion of replacement of Toner Container. Also, to prevent the replacement of a Toner Container that can still
be used.
Low remaining toner in container
-
Replacement not yet needed.
Depends on the service mode
setting *1
Toner supply count
ALARM-2
(Yellow, Cyan, Magenta, Black)
toner is low. (Replacement not
yet needed.) *2
Depends on the service mode
setting *3
-
78
2. Technology
Toner Container Empty
Replace the toner cartridge (yellow,
cyan, magenta, black).
Host machine is stopped.
When the output signal from the To-
ner Density Sensor does not fall be-
low the designated value even after
performing a toner supply operation
Toner Density Sensor
ALARM-2