Table of Contents
Advertisement
6. Remove the ITB [1].
CAUTION:
Install the ITB by inserting paper between the belt and the frame as shown in the figure below.
• A new ITB comes with dedicated paper.
NOTE:
When the consumable parts have been replaced, be sure to clear the parts counter shown below in service mode.
• COPIER > COUNTER > DRBL-1 > TR-BLT
It is also cleared at the same time when TR-UNIT is cleared.
After installation, execute [Auto Adjust Gradation> Full Adjust], [Auto Correct Color Mismatch].
Removing the Primary Transfer Roller (Y/M/C/BK)
■ Preparation
1. Remove the ITB
Unit."Removing the ITB" on page 213
217
4. Parts Replacement and Cleaning
[1]
Advertisement
Table of Contents
Troubleshooting
