Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 960

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
SW-UP-RL 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
INSTP-F1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
INSTP-R1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj of swing unit height:Fin-AA1
To adjust the height of the Swing Unit.
As the value is changed by 1, the height of the Swing Unit is changed by 0.1 mm.
+: Move down
-: Move up
When replacing the Finisher Controller PCB/clearing RAM data, enter the value of service label.
- When misalignment occurs due to failure of paper feeding to the Process Tray
- When replacing the Finisher Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-30 to 30
0
0.1
Adj front 1-stapling position: Fin-K1
To adjust the front 1-staple position.
As the value is changed by 1, the staple position is moved by 0.1 mm.
+: Toward rear
-: Toward front
When replacing the Finisher Controller PCB/clearing RAM data, enter the value of service label.
- When the staple position in front/rear direction is displaced at front 1-stapling
- When replacing the Finisher Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
Adj rear 1-stapling position: Fin-K1
To adjust the rear 1-staple position.
As the value is changed by 1, the staple position is moved by 0.1 mm.
+: Toward rear
-: Toward front
When replacing the Finisher Controller PCB/clearing RAM data, enter the value of service label.
- When the staple position in front/rear direction is displaced at rear 1-stapling
- When replacing the Finisher Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
938
8. Service Mode