E531-8002-02: A. Stapler Motor Error (Finisher-K1) B. Staple Hp Error (Finisher-Aa1); E532-8001-02: A. Stapler Shift Motor Error (Finisher-K1) B. Stapler Shift Hp Error (Finisher-Aa1) - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

E531-8002-02
Detection Description
Remedy
E532-8001-02
Detection Description
Remedy
a. Stapler Motor error (Finisher-K1) b. Staple HP error (Finisher-AA1)
a. The Staple HP Sensor was not turned ON although 0.4 seconds had passed after the Stapler
Motor operation started.
b. The Staple HP Sensor does not detect the staple although the Staple Motor has been driven
for 0.4 seconds.
a. INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Unit
- Stapler Unit (including the Stapler Motor and the Staple HP Sensor)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Unit
- Stapler Unit (including the Staple Motor (M111) and the Staple HP Sensor (PI50))
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
a. Stapler Shift Motor error (Finisher-K1) b. Stapler Shift HP error (Finisher-AA1)
a. The Stapler Shift HP Sensor was not turned OFF although 1 second had passed after the Stapler
Shift Motor operation started.
b. The stapler unit does not come off the Stapler Shift HP Sensor although the Stapler Shift Motor
has been driven for 5 seconds.
a. INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Shift HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Shift Motor
- Stapler Shift HP Sensor (PS11)
- Stapler Shift Motor (M7)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Shift HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Shift Motor
- Stapler Shift HP Sensor (PI110)
- Stapler Shift Motor (M105)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
395
7. Error/Jam/Alarm