E530-8002-02: A. Rear Alignment Motor Error (Finisher-K1) B. Front Aligning Plate Hp Error (Finisher-Aa1); E531-8001-02: A. Stapler Motor Error (Finisher-K1) B. Staple Hp Error (Finisher-Aa1) - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

E530-8002-02
Detection Description
Remedy
E531-8001-02
Detection Description
Remedy
a. Rear Alignment Motor error (Finisher-K1) b. Front Aligning Plate HP error (Finisher-AA1)
a. The Rear Alignment Plate HP Sensor was not turned ON although 5 seconds had passed after
the Rear Alignment Motor operation started.
b. The Front Aligning Plate HP Sensor does not detect the front aligning plate although the Front
Aligning Plate Motor has been driven for 4 seconds.
a. INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Rear Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Rear Alignment Motor
- Rear Alignment Plate HP Sensor (PS5)
- Rear Alignment Motor (M4)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Aligning Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Aligning Plate Motor
- Front aligning plate drive mechanism
- Front Aligning Plate HP Sensor (PI106)
- Front Aligning Plate Motor (M103)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
a. Stapler Motor error (Finisher-K1) b. Staple HP error (Finisher-AA1)
a. The Staple HP Sensor was not turned OFF although 0.4 seconds had passed after the Stapler
Motor operation started.
b. The staple does not come off the Staple HP Sensor although the Staple Motor has been driven
for 0.4 seconds.
a. INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Unit
- Stapler Unit (including the Stapler Motor and the Staple HP Sensor)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stapler Unit
- Stapler Unit (including the Staple Motor (M111) and the Staple HP Sensor (PI50))
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
394
7. Error/Jam/Alarm