Xerox WorkCentre Pro 423 Service Manual page 318

WorkCentre Pro 423/428
6. Remove the In-Roller Assembly. (Figure-3)
1) Release the Hooks (2) and remove the Pulley.
2) Remove the Bearing.
3) Extract the Pin.
4) Remove the In-Roller Assembly.
(Figure-3) j0hn4d28
Installation
Procedure
1. Perform the removal steps in reverse order.
4-44
03/02
REP 13.14.3 Lower Paper Guide
Ref. PL: PL13.14
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Remove the following parts.
1) Finisher Assembly (REP13.1.1)
2) Exit Roller Assembly (REP13.14.1)
3) L/H Upper Cover (PL13.9)
2. Remove the Upper Paper Guide. (Figure-1)
1) Remove the screws (2).
2) Disconnect the Connector and extract it from the
hole.
3) Remove the Upper Paper Guide.
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
3. Remove the L/H Lower Guide. (Figure-2)
1) Remove the screw.
2) Remove the Guide Pin.
3) Remove the L/H Lower Guide.
4.2 Disassembly and Assembly
(Figure-1) j0hn4d29
(Figure-2) j0hn4d30