Xerox WorkCentre Pro 423 Service Manual page 281

4. Remove the R/H Lower Cover. (Figure-1)
1) Remove the screws (2).
2) Remove the Handle.
3) Remove the screws (2).
4) Remove the R/H Lower Cover.
(Figure-1) j0hn4204
WorkCentre Pro 432/428
5. Remove the OCT Assembly. (Figure-2)
1) Disconnect the connectors (2).
2) Remove the screw.
3) Push in the Rear Upper Rail.
4) Loosen the screws (2).
5) Remove the screws (2).
6) Remove the OCT Assembly.
(Figure-2) j0hn4206
Installation
Procedure
1. Perform the removal steps in reverse order.
03/02
4-7 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
REP 2.11.1 Registration Chute Assembly
Ref. PL: PL2.11
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
WARNING
After switching off the machine the fuser
surfaces are still hot. Allow to cool, or avoid
contact while working near the fuser.
CAUTION
Be careful not to damage parts by static electricity.
Electronic parts may be damaged by static electricity. Be
sure to wear a wristband when handling electronic parts. If
no wristband is available, touch the metal frame before work
to eliminate static electricity as far as possible.
Procedure
1. Pull out the R/H Unit.
2. Remove the Fuser Assembly. (PL6.1)
3. Disconnect the Connectors and release the Wire
Harness. (Figure-1)
1) Lift the Registration Chute Assembly.
2) Disconnect the Connector.
3) Disconnect the Wire Harness and release from
the Clamps (4).
4) Disconnect the red wire.
5) Disconnect the white wire.
4.2 Disassembly and Assembly