Xerox WorkCentre Pro 423 Service Manual page 304

WorkCentre Pro 423/428
3. Remove the DADF Feed/Nudger Roll Assembly.
(Figure-2)
1) Remove the KL-Clip.
2) Remove the Bearing.
3) Remove the DADF Feed/Nudger Roll Assembly.
(Figure-2) j0hn4a11
4. Remove the DADF Nudger Roll.
1) Remove the Set Gate.
2) Remove the KL-Clip.
3) Remove the pins (3).
4) Extract the Shaft.
5) Remove the DADF Nudger Roll.
4-30 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
03/02
(Figure-3) j0hn4a12
Installation
Procedure
1. Perform the removal steps in reverse order with the
following notes in mind.
Note When installing the chute, insert the
projections (2) securely into the Top Cover
holes. (Figure-4)
Projections
(Figure-4) j0hn4a13
4.2 Disassembly and Assembly
REP10.5.2 DADF Feed Roll
Ref. PL PL10.5
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Open the Top Cover.
2. Remove the chute. (Figure-1)
1) Press both sides of the Top Cover in the
directions of the arrows to release the Hooks
(2).
2) Remove the Chute.
(Figure-1) j0hn4a10