Xerox WorkCentre Pro 423 Service Manual page 279

2. Install the Size Cam while aligning its hole with the
U groove of the Tray. (Figure-2)
1) Install the Size Cam.
2) Insert the Lock Pin.
(Figure-2) j0hn4202
WorkCentre Pro 432/428
REP 2.4.1 R/H Chute Assembly
Ref. PL: PL2.4
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Pull out the R/H Unit.
2. If the machine has an F/U Tray, remove the F/U
Tray. (PL2.4)
3. If the machine has an MSI, remove the MSI.
(REP11.1.1)
4. Remove the Exit Assembly (REP2.4.2) or the OCT
Assembly (REP2.4.3).
5. Remove the R/H Chute Assembly. (Figure-1)
1) Remove the screws (2).
2) Remove the screws (2).
3) Remove the R/H Chute Assembly.
03/02
4-5
Installation
Procedure
1. Perform the removal steps in reverse order.
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
(Figure-1)j0hn4203
4.2 Disassembly and Assembly