Xerox WorkCentre Pro 423 Service Manual page 316

WorkCentre Pro 423/428
3. Remove the Compiler Motor. (Figure-2)
1) Remove the screws (2).
2) Pull out the Compiler Motor.
3) Remove the Screw and the Earth Wire.
4) Release the Clamp and remove the Wire.
5) Disconnect the connectors (2).
(Figure-2) j0hn4d23
Installation
Procedure
1. Perform the removal steps in reverse order.
4-42
03/02
REP 13.14.1 Exit Roller Assembly
Ref. PL PL13.14
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Remove the Finisher Assembly. (REP13.1.1)
2. Remove the Reverse Motor Belt. (REP13.5.1)
3. Remove the Front Cover. (PL13.17)
4. Remove the Lever. (Figure-1)
1) Remove the spring.
2) Remove the Lever.
(Figure-1) j0hn4d24
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
5. Remove the Bearing. (Figure-2)
1) Remove the Bearing.
2) Slide the Roller in the direction of the arrow.
4.2 Disassembly and Assembly
(Figure-2) j0hn4d25