Auxiliary Alarm Signaling Equipment; Figure 9-1: Configuration Of The 7720P To The J5 Output Triggers - ADT FOCUS 200 PLUS Installation And Setup Manual

Commercial fire and burglary security system with scheduling
Hide thumbs Also See for FOCUS 200 PLUS:
Table of Contents

Advertisement

FOCUS 200 PLUS Installation and Setup Guide

Auxiliary Alarm Signaling Equipment

The J5 output triggers may be used to trip auxiliary alarm signaling equipment such as ADEMCO's
7720P, 7835C, 7830R, and 7920SE Long Range Radios.
These units are typically used as a backup to the Telco lines. They may be configured to send signals
when the system detects a Telco line fault. Refer to Figures 9-1, 9-2, 9-3 and 9-4 for the wiring and
configuration of the Long Range Radios to the J5 output triggers.
When a Long Range Radio is installed, configure the sense select for zones 1 and 2 in the Long Range
Radio to activate on +5V (positive trigger). This is necessary to prevent false alarms from occurring. Refer to
the installation instructions provided with your radio for instructions on setting the zone 1 and 2 levels.
FOCUS 200 PLUS
AUX. Relay N.O.
J5
Output
Triggers
FOCUS 200 PLUS Setup:
Set the P3 Jumper to 'WET'
Program the AUX. Relay to activate
on any BA [ABA]
Program Output 6 (Point 253) to
activate on Fire (type 21, FA)
Program Output 7 (Point 254) to
activate on Holdup (type 23, HU)
Program Output 8 (Point 255) to
activate on Telco Fault (type 16)
Use any of the eight Hardwired
Inputs (ZN 1-8) on the control and
Program this point as an FI
(Type 1), or an SPV (Type 13) to
monitor Radio Fault
9-4
11
12
Ground
Out 5
6
Yellow
Out 6
7
Gray
Out 7
8
Violet
Out 8
9
2k EOLR

Figure 9-1: Configuration of the 7720P to the J5 Output Triggers

7720
SafetyNet Radio
Power
16.5VAC / 40VA
Ground
Zone1
Zone 2
Zone 3
Zone 4
ECP In
ECP Out
Radio Fault
Output
J3
J2
J1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents