Mechanics Of Programming; Programming Names For The Ba Groups - ADT FOCUS 200 PLUS Installation And Setup Manual

FOCUS 200 PLUS Installation and Setup Guide

Mechanics of Programming

The operating panel provides an interactive display that operates in a manner similar to an automatic
teller machine (ATM). It employs a 19-character, four-line LCD display that shows menu selections,
message prompts, and help screens to guide you through the various operating procedures. Menu items
and other selectable choices are shown on the screen with an arrow (>) that lines up with one of the
four "Selector" buttons on each side of the screen. You make a choice by pressing the button alongside
the item shown on the screen.
Programming of the system is done by selecting a course of action from menu items that appear on a
series of screens known as Action Menus. Entering the valid Service Code will cause the first of four
Action Menus to be displayed. The Action Menus are the starting point for performing all programming
operations.
In order to access the Action Menus, the protection for the BA group associated with the operating panel
where the Service Code is entered must be Off.

Programming Names for the BA Groups

Enter the program mode by entering the Service Code at the operating panel.
< ?
< Lesson
< See alarms
< Quit
< ?
< Sys info
< Name pnt/gps
< Previous
< ?
Group 1
< Prev
< Quit
< ?
Group 1
< Back
< Left
14-2
Action Menu #1 is displayed.
Enter choice:
Select More three times.
Turn on >
Reset >
More >
Action Menu #4 is displayed.
Enter choice:
ID codes >
Select Name pnt/gps.
Load >
First >
Group Info Screen is displayed. The default display shows the
GROUP #1
info for Group #1.
The top line shows the current name. The second line shows the
Change >
group to which this info pertains.
Next >
Select Next to display the info screen for Group #2. Select Next
again to display the info screen for Group #3, etc. Select Prev to
display the previous group's info.
Select Change to move to the Character Entry Screen for the group
displayed.
The cursor is under the first letter of the current name for the
GROUP #1
group. Use the third key down on each side to move either Back or
Done >
Forward through the alphabet. Use the bottom key on each side to
CHR Forward >
move the cursor position either Left or Right through the name.
POS Right >
Select Done to save the current name displayed. The system
displays the Group Info Screen.
Program all group names by selecting either Next or Prev to move
to another group.
Select Quit twice to exit the program mode.