Alarm Help Messages - ADT Galaxy 8 User Manual

Galaxy 8/18/60/500/512
ALARM AND HELP MESSAGES
OTHER KEYPAD
IN USE
ALARM IN
PROGRESS
2)
4-5-6 4-3714-,
CALL MANAGER
RESET REQUIRED
CALL MANAGER
RESET REQUIRED
NO ENTRIES
INVALID
OPTION
Invalid code
Option not
available
CALL ALARM CO.
QUOTE CODE XXXXX
Technical Manuals Online! - http://www.tech-man.com
OTHER KEYPAD IN USE (GALAXY 8 and 18 only)
This message advises the user that the system is already in use. The Galaxy 8
and 18 allow only one user at a time.
ALARM IN PROGRESS
The system is currently in alarm condition and must be cancelled by a valid
PIN or keyswitch operation.
PA RESET REQUIRED
After a PA (Personal Attack) zone has been activated the system has to be
reset by a high level code (such as a manager or engineer depending on the
reset level setting).
MANAGER RESET REQUIRED
Following alarm activation the system requires to be reset by a manager
e.
level cod
ENGINEER RESET REQUIRED
Where the system has been programmed for engineer reset, following an
activation the alarm engineer must be called to reset the system before the
user can set the alarm.
Tamper alarms usually require an engineer to visit the site to check all
modules on the system. This message is displayed when a tamper alarm
occurs.
NO ENTRIES
This message appears if a user attempts to view or inspect the log and there
is nothing in the log to be viewed or when the omit option is selected and
there are no omittable zones on the system.
INVALID SELECTION
The option selected or value entered is illegal or out of range.
INVALID CODE
The code entered is not a valid code registered in the system memory.
OPTION NOT AVAILABLE
The option selected is not operational.
TECHNISTORE RESET
Call the Alarm Monitoring Station and quote the five digit number
displayed. Enter the number quoted by the monitoring station to
reset the system.
27 User Guide