ADT FOCUS 200 PLUS Installation And Setup Manual page 173

Alarms/Point Status
•
View the points of protection that are off-normal.
•
Reset sensors at the various points of protection (provided sensors have restored to normal).
•
Silence BA/FA sounding devices and operating panel sounder (by entering valid code).
•
View contents of alarm memories.
•
Restore alarm memories.
•
Initiate printout or view contents of alarm memory log.
Schedules/Time
•
Close late by temporarily changing the close time schedule for any BA group (for up to 6
consecutive days from the current day).
•
Establish or change permanent opening and closing schedules for each BA group.
•
Establish or change earliest time for opening and latest time for closing each BA group.
•
Establish temporary opening and closing schedules for each BA group for a maximum of six
consecutive days.
•
Establish automatic On and/or automatic Off schedule (if system option has been enabled).
•
Establish or change the holiday schedules (holiday name and date).
•
Establish or change a hostage schedule.
•
Set and adjust time and date.
Note: There are two different privileges for changing time:
1. Allowed to change time by plus or minus 5 minutes in any day, but allowed to make a full
change when the system is first powered up.
2. Always allowed unlimited time changes. Entered values of digits for hours must not be 00 and
must not be greater than 12.
Bypassing
•
Bypass any point(s) in the system.
•
View points that are bypassed.
Any BA point that has been bypassed will automatically become unbypassed when the system is turned
from On to Off at the operating panel.
Special bypass of vault vibration sensor points will automatically become unbypassed at BA1 Latest Close
Time, or at midnight if Latest Close Time is not set.
Resetting
•
Reset alarms.
•
Reset results of walk tests and other sensor tests.
•
Reset Memory (SRAM).
ID Codes
•
Establish or change ID codes.
•
Establish or change privilege levels for ID codes.
•
Establish or change BA group(s) assigned to an ID code.
•
View ID code privilege levels and name of person associated with each code.
Section 18 – ID Codes
18-5