Programming The Ba Groups' Turn-Off Data - ADT FOCUS 200 PLUS Installation And Setup Manual

FOCUS 200 PLUS Installation and Setup Guide
< ? FRONT DOOR 20
Gate?
< Previous
< ? FRONT DOOR 20
Gate 1
< Previous
< ? FRONT DOOR 20
< Replace (N)
Hard ID: _ _ _ _ _ _ _ _
< Previous
< ? FRONT DOOR 20
Pnt 20
< Prev
< Quit

Programming the BA Groups' Turn-Off Data

Enter the program mode by entering the Service Code at the operating panel.
< ?
< Lesson
< See alarms
< Quit
< ?
< Sys info
< Name pnt/gps
< Previous
< ? BA GROUP #1
< Previous
< Quit
14-6
Continue >
POINT GATEWAY
Delete >
Continue >
POINT GATEWAY
Enter >
Done >
Enter >
Type 3MD
Change >
Next >
Enter choice:
Turn on >
Reset >
More >
Enter choice:
ID codes >
Load >
First >
Group 1
Change >
Next >
This is the Gateway Screen.
Enter the Gateway unit number (0-7) that this point is associated
with.
Select Continue to save the info and move to the next screen.
Select Enter and then Continue to save this info and move to the
next screen.
This is the Hard ID Screen.
Enter the Hard ID number of the device for the point.
If this is an RF point, enter the serial number located on the bar
code label on the transmitter.
Select Enter and then Done to save this info and move back to the
Point Info Screen.
Note: The Replace (Y/N) has no function at this time.
This is the Point Info Screen.
This screen now displays the summary information for the point.
The first line shows the current name and the second line shows
the point and the type.
Select Next to display the info for the next point.
Select Previous to move back to the previous screen.
Select Change to edit the info for this point.
Select Quit and move to Action Menu #4 when all points have been
programmed.
Action Menu #1 is displayed.
Select More three times.
Action Menu #4 is displayed.
Select Name pnt/gps.
Group Info Screen. The system defaults to display the info for
Group #1. The top line shows the current name. The second line
shows the group to which this info pertains.
Select Next repeatedly until the info screen for Group #8 is shown.
Select Next once more to advance to the next screen.