Specifications; Electrical/Mechanical Specifications - ADT FOCUS 200 PLUS Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Electrical/Mechanical Specifications

Installation Criteria
Approvals
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Electrical/Mechanical Specifications
AC Transformer
For Secondary Wire Runs
Up to 10' in Length
Battery (standby)
Type
50VA Transformer
72VA Transformer
Charge Voltage to Battery
Float Charging Voltage
Fuse (FS)
Low-Battery Signal
Low-Battery Cutoff
Control Unit Power Output to RS-485 Buses
Nominal with AC Connected
Max. Current
Fuses Fl (RS-485 #1) and F2 (RS-485 #2)
Maximum RS-485 Bus Load Current
(Standby Condition)
4-Hr. (7AH Battery)
24-Hr. (34.4AH Battery)
72-Hr. (34.4AH Battery)

Specifications

120V, 60 Hz (Primary)
18V, 60 Hz, 50VA or 72VA (Secondary)
12VDC Sealed lead-acid battery
7AH min. - 24AH max.
7AH min. - 34.4AH max.
13.65VDC (nominal)
PTC Resetable Fuse (nonreplaceable)
12.0VDC (nominal)
9.8VDC
13.65VDC
1.0A (Actual allowed is conditioned on
Standby Battery capacity provided; see below)
PTC Resetable Fuse (nonreplaceable)
1.0A
1.0A
132mA
S E C T I O N 2 1
21-1