Resetting/Silencing Your System After An Alarm - ADT Smart Home PM360-R Quick Consumer Reference Manual

Step 4
A 30 second exit delay countdown
is displayed, this is the time left for
leaving your home or leaving the
home areas protected by the
peripheral security sensors, before
the alarm panel is partial set.
Step 5
After a few seconds, the Lock icon
becomes yellow, indicating that
the ADT Smart Home Security
panel is partial set.

Resetting/Silencing your System after an alarm

To stop the Alarm sounding using the Keypad – by pressing the "unset" key
and entering your 4-Digit User Code /or presenting your Keyfob.
Important: Resetting/Silencing your System stops the Internal Sounder ringing but
will not interrupt the transmission of the alarm signal to the ADT Alarm Monitoring
Centre. Our monitoring specialists may contact you at this point and you will be
requested to confirm your Verification Code /Password to cancel the alarm alert. Your
System might be required to be reset remotely
10