ADT FOCUS 200 PLUS Installation And Setup Manual page 55

Transmitter Input Types
All of the transmitters described have one or more unique factory-assigned inputs (loops). Each of the
inputs requires its own programming point (e.g., 5804's four-button inputs require four points).
Transmitters can be programmed as one of the following types:
Type
RF
Supervised RF)
UR
(Unsupervised RF)
BR
(Unsupervised Button RF)
Transmitter Supervision
Except for some transmitters that may be carried off premises (5802MN, 5804), each transmitter sends
a supervisory signal to the RF receiver every 70–90 minutes. If at least one signal is not received from
each supervised transmitter within a programmed check-in interval, the "missing" transmitter(s) will
display a trouble condition. For transmitters that may be carried off the premises (5802MN), turn off
the supervision by programming it as a "UR" (unsupervised RF) type.
The system is shipped with the transmitter check-in interval defaulted to (0) no supervision. Be sure to
program a check-in interval if you are using supervised transmitters. Otherwise, the system will not
annunciate a supervisory trouble condition from those transmitters.
Some 5800 Series transmitters have built-in tamper protection and will annunciate a trouble condition
if covers are removed.
Transmitter Battery Life
•
Batteries may last from 4 to 7 years, depending on the environment, usage, and the specific
wireless device being used. Factors such as humidity, high or low temperatures, as well as large
swings in temperature may all reduce the actual battery life in a given installation.
•
The wireless system can identify a true low-battery situation, thus allowing the dealer or user time
to arrange a change of battery and maintain protection for that point within the system.
•
Button-type transmitters (e.g., 5804) must be periodically tested for battery life.
Testing the Transmitters
For information about how to test the transmitters, refer to the Testing the System section.
Compatible 5800 Series Transmitters
Model Product
5802MN Miniature (Personal
Emergency Transmitter)
5804 Wireless Key Transmitter
5816MC Money Clip Transmitter
Description
Sends Fault, Restore, Low Battery signals and periodic Check-in
signals. The transmitter must remain within the receiver's range.
Sends same signals as RF type, but the control does not supervise
Check-in signals. The transmitter may be carried off-premises.
Sends Fault signals and Low Battery signals, only when activated
(button pressed). The transmitter may be carried off-premises.
Input Type
UR or RF
BR Only
RF
Section 5 - Gateways
Description
•
Has single pushbutton.
•
If you are using this for
arming/disarming, the button must be
assigned to a user code.
•
Contains a replaceable battery.
•
Has four pushbuttons, each with a
unique input (loop).
•
Contains a replaceable battery.
•
If you are using this for
arming/disarming, the button must be
assigned to a user code.
•
Has a normally closed contact loop.
•
Typically used in a cash drawer.
•
Triggers when all the money is
removed from the money clip.
5-27