ADT FOCUS 200 PLUS Installation And Setup Manual page 104

FOCUS 200 PLUS Installation and Setup Guide
Level
4
5
6
7
8
Note: Basic privilege assigned to each code allows user to turn BA protection On and Off for assigned
BA group(s), and to perform tests.
Assigning Access and Privileges for Users
Perform the following steps to enter the card/key access data for a user via the operating panel. See the
ID Codes section for the procedure on entering access capabilities of users using ID Codes.
Enter the Service Code at an operating panel.
< ?
< Lesson
< See alarms
< Quit
< ?
< Sys info
< Name pnt/gps
< Previous
< PERSON #1
< Previous
< Quit
<
<
< Quit
< ?
<
< Quit
< ?
<
< Quit
< ?
<
< Quit
10-18
Privilege
Ability to change person/point/BA group descriptions, and privilege level. Ability to change
ID code accessibility to BA group.
Ability to bypass fire, holdup, or supervisory points, and to conduct FA sensor test.
Service − ADT on-premises signal is transmitted to CCC when the ID code is entered and
will lock out all other ID codes. This privilege must be assigned to all Service ID codes, and
is not to be made available to the customer.
Operating panel code and/or card/key code is permitted to be changed by person having a
code with Level 4 privilege.
Janitor − Use of valid card/key will cause the alarm shunting of any Janitor BA points in
the associated BA group(s).
Enter choice:
Turn on >
Reset >
More >
Enter choice:
ID codes >
Load >
First >
USER 001 Delete >
Change >
Next >
Insert or swipe
key or card
1 A 7 7 3 9 6 3
Continue >
Code and card
will be deleted
on 08/21
Enter >
Code and card
will be deleted
on 08/21
None >
Code and card
will be deleted
on 08/21
None >
Action Menu #1 is displayed.
Select More three times to display the last action menu.
Action Menu #4 is displayed.
Select ID codes.
Person Data Entry Screen is displayed.
Pressing the [#] key at this screen will bring you to the Enrolling
Key or Card Screen. Also pressing Continue at the last access
screen "ID code may (not) be changed" for BA Group 8 will bring
you to that screen.
The Enrolling Key or Card Screen is displayed.
Insert the key or swipe the card in the reader. An 8-digit number
will be displayed.
Select Continue to move to the next screen.
The Person's Deletion Date Screen is displayed.
Enter the digits for the month and day after which the person will
be prevented from using the system.
Select Enter to register the date in the system.
After you press Enter, that button changes to None.
Select None to delete the date and/or change it.
Select Quit to return to the Person Data Entry Screen.