ADT FOCUS 200 PLUS Installation And Setup Manual page 4

Item
Relay Outputs
Built-in 4-Wire Smoke
Detector Reset
Cabinet
Wireless (RF) Support
Additional Point
Types
Cabinet Back Tamper
Cabinet Tamper
Auto Cabinet Tamper
Bypass
Primary Phone
Number Programming
Earth Ground Fault
Detection
SRAM
The FOCUS 200 PLUS System Installation Vital Information
Use the following table to record the vital information for this installation. We recommend you leave
this table with the control unit.
Job Location
System Number (SS)
Group Number (GG)
Instrument Number (II)
Service Terminal Phone Number
CCC Phone Number
CCC Communication Type (check the
appropriate boxes)
iv
FOCUS 200B
3 optional relay outputs (relays 1, 2 & 3)
None
FOCUS 200B cabinet
None
Not supported
Mounted on the main PC Board
Not supported
Can only be edited via the downline loader
None
32k bytes
•
2 built-in bell outputs (bell 1 & bell 2)
rated at 12VDC, 1.7A.
•
Built-in auxiliary relay that may be
set for Dry (28VAC/VDC, 2.0A) or Wet
(12VDC, 1.7A) operation.
Uses the auxiliary relay
•
Set Jumper P3 for wet operation
•
Program the relay output point type
for 4-wire smoke detector reset (output
point type 23)
Vista-100 cabinet
Supports all ADEMCO 5800 Series
transmitters except 5804BD, 5827BD, and
5827
•
Arming (65 - ARM) (RF devices only)
•
Disarm (66 - DAR) (RF devices only)
•
No Alarm Response (67 - NAR) (RF
devices only)
Supports back tamper for commercial
burglary applications
Mounted on the side of the cabinet and
connects to the tamper input (J5 trigger 3)
Tamper is automatically bypassed when
the system goes into Service Mode
Can be edited from either the downline
loader or the operational panel
Is a built-in function and is mapped to
point 245
128k bytes
ADT SIA (FSK) CID
FOCUS 200 PLUS
AC Module