Start-up
configuration
program parameters
Fig. 46: Selecting the configuration mode
Available configuration modes:
•
Configuration system parameter
•
Configuration program parameter
•
Data backup
•
Firmware update
System parameters are general adjustments (e.g. language).
Program parameters are application specific adjustments (e.g. input of nominal sheet thickness).
7.6
Program parameters
The program parameters contain the information required for the various measurement programs.
For accessing the program parameters, select the mode "configuration program parameter" and
confirm with ENTER.
Program parameter 1: Selecting the measuring program to be configured.
program par.
program no.:
Fig. 47: Selecting the program to be configured
Here the measuring program (1-255) to be configured is selected. All following adjustments apply
to the selected program (here: program no. 1).
Program parameter 2: Selecting the sensor to be used for measurement.
program par.
sensor:
Fig. 48: Selecting the sensor
Possible choices:
•
2PW-units: 1 / 2 / 1+2
•
with SSB: 1 / 2 / 3 / 4
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
108
Double Sheet Detector R1000 series UDK20
with integrated fieldbus interface
Note
After exiting the configuration mode the password remains active for five
minutes. Thus other configuration adjustments can be made, without re-
entering the password. If no key is pressed (while in the menu level), then
the program changes to the measurement mode
1
1
2
1
Manual
B0048191 / Rev. 1.5