Automatic Tool Changer - Roland R1000 Series Manual

Electrical installation
4.4

Automatic tool changer

The Roland sensors can be used within an ATC concept (Automatic tool change).
The only requirements we have established are:

Every sensor signal must have its own contact.

The contacts must be low resistive (only gold contacts!).

The contacts must be suited for peak currents of 2 ampere.

The shielding of the cable must not be interrupted and therefore have its own contact.

The contacts must be protected from contamination.

Do not route the cable together with other cables leading high currents.

Die metallic parts of the tooling have to be grounded.

It is not allowed to open the connector during the measuring operation.

After each tool change it is required to perform a zero set command.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
50
Double Sheet Detector R1000 series UDK20
with integrated fieldbus interface
Attention Incorrect wiring may destroy the control unit or the sensor.
Manual
B0048191 / Rev. 1.5