Exchange Of Control Unit - Roland R1000 Series Manual

Maintenance
For a 2PW control unit with up two sensors:
1 Verify that no sheet is in front of the sensor resp. the sensors
2 Press the MENU key, switch to "change" and confirm with the ENTER key
3 Enter the password
4 Switch to "program parameter" and confirm with the ENTER key
5 Verify that no sheet is in front of the sensor resp. the sensors
6 Switch to "zero adjust" and confirm with the ENTER key
7 Select "zero adjust: separate" or "zero adjust: common"
7.1
7.2
8 The display "zero adjust: active" appears, and then "zero adjust: off"
9 Leave programming with the MENU key.
10.2

Exchange of control unit

Exchange with help of the RPP software (only with C-versions):
The UDK20 provides for backup and re-writing the equipment parameters via the RS232 interface,
with help of the provided RPP software.
Exchange without help of the RPP software:
After exchanging the equipment, the original system configuration must be restored. Therefore, the
form „System Configuration" in chapter „Technical Documents" (which had been filled out during
set-up) can be used. If this form is not available or filled out, the information on the system
configuration must be retrieved from the equipment documentation.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
136
Double Sheet Detector R1000 series UDK20
with integrated fieldbus interface
If "zero adjust: separate", then confirm with ENTER key
7.1.1 Display: "zero adjust S1: on / remove sheet"
If zero adjusts desired, then ENTER key, or
if zero adjusts not desired, then activate "off" and confirm with ENTER
7.1.2 Display: "zero adjust S2: off"
If zero adjusts not desired, then press ENTER key, or
if zero adjusts is desired, then activate "on" and press ENTER
If "zero adjust: common", then confirm with ENTER key, all connected sensors are
zero adjusted.
Manual
B0048191 / Rev. 1.5