Setup - Program Selection - Roland R4000 Manual

B0059001 / Rev. 2.3
7.3 Setup – Program selection
Administration of the measuring programs.
Fig. 38: Setup program selection
Pos: 52 /Sc hweis snaht/ Geräte/ SN D40/8 Bet rieb/Rundkö rpe r/Ein ric hten Te stbet rieb @ 0\mod_ 1186 483 245 937_ 501. docx @ 4 463 @ 2 @ 1
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Switches this program active, on which the
cursor is just placed. The currently active
program will be switched passive.
Sets up a new program at the empty program
space, on which the cursor is just placed.
Therefor the unit switches over to the mode
"setup operation".
The unit switches over to the mode
"setup operation".
Deletes the program, on which the cursor is
just placed.
Copies the program, on which the cursor is
just placed on, into the clipboard. For storing
this program onto another program place,
select an empty program place and press the
"Insert" key.
Manual
Prints out the program list.
No key function in this mode.
Selects the parameters from
the list.
No key function in this mode.
Operation
71