Frymaster Enodis BIELA14 LOV Series Operator's Manual page 86

Problem
Filter pump runs,
but oil return is very
slow (contd).
M2007 display
shows chk pan.
Auto filtration won't
start.
M2007 display
shows filter
busy.
Probable Causes
B. Attempting to filter with oil that
is not hot enough.
A. Filter pan is not fully set into fryer.
B. Missing filter pan magnet.
C. Defective filter pan switch.
A. Check that MIB board is not in
manual mode.
B. Check to see that the MIB cover is
not damaged and depressing the
buttons.
C. Filter relay has failed.
Another filtration cycle is still in
process.
Corrective Action
B. In order to properly filter, the
oil should be at or near 350ºF
(177ºC).
lower than this, the oil becomes
too thick to pass through the
filter medium easily, resulting
in much slower oil return and
eventual overheating of the
filter pump motor. Make sure
oil
temperature before draining oil
into filter pan.
A. Pull filter pan out and fully
reinsert into fryer.
B. Ensure the filter pan magnet is
in place and if missing replace.
C. If the filter pan magnet is fully
against
computer continues to display
chk
possibly defective.
A. Ensure MIB board is in "A"
automatic mode. Press the reset
button.
B. Remove and replace cover and
see if filtration will start.
C. Call your FASC
A. Wait
filtration cycle ends to start
another filtration cycle.
B. Press reset button and wait at
least 60 seconds.
should clear and return to
normal
complete.
continues call your FASC.
7-8
At temperatures
is at or near frying
the switch and
pan,
switch
until the previous
Computer
operation once
If the problem
is