Frymaster Enodis BIELA14 LOV Series Operator's Manual page 14

3.3 Low Oil Volume Automatic Refill
When the optional Low Oil Volume
(LOV) system is in place on the fryer, oil
is continually topped off in the frypots
from a reservoir in the cabinet. The
reservoir holds a 35 pound box of oil. In a
typical operation
approximately two days before changing.
Components of the system are annotated
at the right (see Figure 1).
NOTE: The system is intended to top
off the frypots, not fill them. The frypots
will require manual filling upon startup
and after boil out.
3.3.1 Prepare the System for Use
To prepare the system for its initial
operation, remove cross brace (see Figure
2). Do not replace the screws. Follow
these instructions to prepare the cabinet
for the installation of the first box of oil
and subsequent boxes of oil.
Prior to installation of the JIB, ensure that
the power switch for the JIB auto top off
system is on. The switch is located inside
the JIB cabinet, on the left side of the JIB
auto top off box, located behind the JIB
(see Figure 3).
3.3.2 Install the Oil Reservoir
Remove the original lid from the oil container and foil liner. Replace with the provided cap, which has
connected suction hardware. Ensure the feeder tube from the cap reaches to the bottom of the oil
container.
Place the oil container inside the cabinet and slide it into place (as shown on the following page).
Avoid catching the suction hardware on the cabinet interior as the container is placed in the fryer.
The system is now ready for operation. As the fryer heats to preprogrammed temperatures, the system
will energize and then slowly add oil to the frypot as needed, until the oil reaches an optimal level.
this will last
Figure 2
Figure 3
3–3
Close up of switch located
on the left side of the JIB
auto top off box.