Frymaster Enodis BIELA14 LOV Series Operator's Manual page 84

Problem
M2007 display
shows PROBE
FAILURE with
alarm sounding.
M2007 display
shows igNITION
FAILURE
with alarm
sounding. Heating
indicator is on, but
fryer is not heating.
M2007 display
shows IGNITION
FAILURE and
alarm sounds, but
fryer operates
normally (false
alarm).
Computer will not
go into program
mode or some
buttons do not
actuate.
Heat indicator off
upon initial startup.
Display shows hi or
hot with alarm
sounding.
Computer locks up.
7.2.3 Filtration Problems
Problem
No power present at
the MIB board
Filter pump won't
start.
Probable Causes
Damaged computer wiring harness
or connector.
Drain valve not fully closed.
Failed computer.
Failed computer.
Failed computer.
Computer error.
Probable Causes
Transformer has failed in left
component box.
A. Power cord is not plugged in or
circuit breaker is tripped.
Corrective Action
Call your FASC
Press the reset switch on the front of
the MIB box, located inside the filter
cabinet.
close.
turn the computer OFF and then ON
again. If the problem continues call
your FASC.
Call your FASC.
Call your FASC.
Call your FASC.
Remove power to the computer using
the master power switch on the
bottom of the component box, located
inside the cabinet. If problem
persists, contact your FASC.
Corrective Action
This indicates a problem that is
beyond the scope of operator
troubleshooting. Call your FASC.
A. Verify that the power cord is
fully plugged in. If so, verify
that circuit breaker is not
tripped.
7-6
All drain valves should
Using the ON/OFF switch,