Resetting The Interface Module (Profinet Io) To Factory Settings With A Reset Button - Siemens SIMATIC ET 200SP System Manual

Maintenance
12.6 Resetting CPU/interface module (PROFINET) to factory settings
Result after resetting to factory settings
The following table shows the values of the interface module properties after a factory reset:
Table 12- 4
Properties
Parameters
IP address
Device name
MAC address
I&M data
Firmware version
Note
Failure of downstream stations is possible
Downstream stations on a bus segment can fail when the factory settings are restored on an
interface module.
Note
Substitute value behavior of the inserted I/O modules on reset to factory settings
The I/O modules of the ET 200SP distributed I/O system do not have the configured status
after a reset to factory settings.
Reference
You will find more information on the procedure in the STEP 7 online help.
12.6.3 Resetting the interface module (PROFINET IO) to factory settings with a
RESET button
Requirement
The supply voltage to the interface module is turned on.
Required tools
3 to 3.5 mm screwdriver (for resetting with a RESET button)
220
Properties of the interface module as shipped
Value
Default setting
Not available
(can be configured when resetting: "Retain IP ad-
dress"/"Delete IP address")
Not available
Available
Identification data (I&M0) available
Maintenance data (I&M1, 2, 3, 4) not available
Available
System Manual, 12/2015, A5E03576849-AF
Distributed I/O system