Siemens SIMATIC ET 200SP System Manual page 138

Protection
8.4 Know-how protection
Setting up block know-how protection
To set up block know-how protection, follow these steps:
1. Open the properties of the block in question.
2. Select the "Protection" option under "General".
Figure 8-2
3. Click the "Protection" button to display the "Know-how protection" dialog.
Figure 8-3
4. Click the "Define" button to open the "Define Password" dialog.
Figure 8-4
5. Enter the new password in the "New password" box. Enter the same password in the
"Confirm password" box.
6. Click "OK" to confirm your entry.
7. Close the "Know-how protection" dialog by clicking "OK".
Result: The selected blocks are now know-how protected. Know-how protected blocks are
marked with a lock in the project tree. The password entered applies to all blocks selected.
138
Setting up block know-how protection (1)
Setting up block know-how protection (2)
Setting up block know-how protection (3)
Distributed I/O system
System Manual, 12/2015, A5E03576849-AF