Overview Of Application Parameters 6 To 55 - Siemens SIPART PS2 Operating Instructions Manual

Set the transmission ratio selector accordingly.
1)
Parameter only appears with "WAY", "-WAY", "ncSLL", and "-ncLL"
2)
If used, the value on the actuator must correspond to the set range of stroke on the lever arm.
3)
Carrier must be set to the value of the actuator travel or, if this value is not scaled, to the next larger scale value.
See also
Commissioning (Page 107)
8.2.2

Overview of application parameters 6 to 55

Introduction
These parameters are used to configure the following additional functions of the positioner:
● Setpoint preparation
● Actual value preparation
● Binary signal processing
● Tight closing function
● Limit detection
Note
Factory-set parameter values are printed in bold in the following table.
Overview
Parameter Function
6.SDIR Setpoint direction
Rising
Falling
7.TSUP Setpoint ramp up
8.TSDO Setpoint ramp down
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
8.2 Tabular overview of the parameters
Parameter values
riSE
FALL
Auto / 0 ... 400
0 ... 400
Parameter assignment
Unit
s
s
135