Connecting Ncs To Emc Filter Module - Siemens SIPART PS2 Operating Instructions Manual

B.2.3

Connecting NCS to EMC filter module

Requirement
You need the EMC filter module, article number 6DR4004-6F or -8F for the electrical
connection of the accessory part "NCS sensor for contactless position measurement" to the
positioner. The positioner supplies auxiliary power to the NCS sensor via the EMC filter module.
Wiring diagram
②
③
④
⑤
⑥
Figure B-7
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
Positioner (open state)
Terminal Ref: Green
Terminal Pos: Black
Terminal GND: Brown
Terminal Vcc: Yellow
EMC filter module
Example of connecting the NCS to the EMC filter module
External position detection
B.2 Non-Contacting Sensor
⑦
Cable clamp
⑧
Screw F3x8
⑨
Cable gland
⑩
Four-pole NCS cable
⑪
Non Contacting Sensor (NCS)
⑫
Cable shielding lug
319