Connect
5.2 Electrical wiring
Procedure
1. Loosen the screw
2. Pull the transparent cover
3. Tighten every cable in the corresponding terminal.
4. Slide the transparent cover
5. Tighten the screw
6. Connect the cables of each switch to the lug of the printed circuit board in pairs. Use the
provided cable ties
Figure 5-10
88
①
on the transparent cover
①
of the transparent cover
③
for this purpose.
①
Screw
②
Cover
③
Cable tie
Connecting the cables
②
②
up to the front end stop.
②
up to the end stop of the basic electronics.
②
.
Operating Instructions, 05/2019, A5E00127926-AC
.
SIPART PS2 with PROFIBUS PA