Siemens SIPART PS2 Operating Instructions Manual page 318

External position detection
B.2 Non-Contacting Sensor
8. Mount the bracket
– Two hexagonal screws
– Spring washer
– Washer
– Hexagonal nut
The selection of the row of holes depends on the yoke width of the actuator. Make sure that
the dog pin
the complete stroke range. The dog pin must not touch the clamping pieces.
9. Place the NCS assembly kit with the mounting bracket
dog pin
10.Tighten the pick-up bracket
11.Prepare the assembly parts for the relevant actuator type for installation:
– For mounting on yoke with fin: hexagonal screw
– For mounting on a yoke with plane surface: Four hexagonal screw
– For actuator with columns: Two U brackets
12.Mount the NCS assembly kit to the yoke using the assembly parts that you prepared.
Note
Observe the height
Adjust the height of the NCS assembly kit so that the lever position is in line horizontally with
the stroke center. Use the lever scale on the actuator for orientation. If a symmetrical
assembly is not possible, you must always ensure that the lever is in horizontal position
within the range of the stroke.
Reference
For information on the scope of delivery, refer to section "NCS sensor scope of delivery
(Page 323)"
318
①
to the NCS mounting kit using:
⑨
⑩
⑰
④
engages in the pick-up bracket
④
is guided inside the pick-up bracket
⑨
and spring washer .
⑨
and spring washer .
⑧
②
②
②
.
⑥
, four hexagonal screw
Operating Instructions, 05/2019, A5E00127926-AC
as close as possible to the spindle over
①
onto the actuator. Ensure that the
.
⑦ ⑩
, washer and spring washer
⑦
⑰
SIPART PS2 with PROFIBUS PA
⑨
.
⑩
with washer
⑩
with washer