Siemens SIPART PS2 Operating Instructions Manual page 48

Installing/mounting
4.3 Mounting to part-turn actuator
1. Rest the actuator-specific VDI/VDE 3845 mount
Tighten the mount using the hexagon bolts
2. Push the coupling wheel
positioner shaft. Then retract the coupling wheel or the stainless steel coupling by
approximately 1 mm. Tighten the hexagon socket-head screw
wrench provided. Maximum tightening torque = 1 Nm. If you are using the stainless steel
coupling, omit the next step.
Note
Coupling wheel
Instead of the polycarbonate coupling wheel
coupling (article number TGX: 16300-1556).
Figure 4-7
3. Place the carrier
screw
Figure 4-8
48
①
or the stainless steel coupling up to the endstop on the
Left: Coupling wheel, right: Coupling wheel, flameproof enclosure
②
on the actuator shaft. Tighten the carrier
⑨ ⑩
and the washer .
Carrier
⑥
on the rear side of the positioner.
⑦ ⑧
and lock washers
⑪
using the machinist's
①
, it is possible to use a stainless steel
②
using the socket cap
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
.