Siemens SIPART PS2 Operating Instructions Manual page 45

9. Install the mounting bracket
2 spring lock washers
Figure 4-5
Figure 4-6
10.Select the row of holes. The selection of the row of holes depends on the yoke width of the
actuator. Select the row of holes in such a way that the carrier pin
up bracket
11.Keep the positioner and the fastening bracket on the actuator. Ensure that the carrier pin
for the entire range of stroke of the actuator is guided inside the pick-up bracket
that the carrier pin
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
①
at the rear side of the positioner. Use 2 hexagon bolts
⑩
and 2 flat washers
Installation with mounting bracket
Installation with mounting bracket, flameproof enclosure
②
near the spindle.
④
does not touch the clamping pieces
4.2 Mounting to linear actuator
⑪
for this purpose.
④
③
.
Installing/mounting
⑨
,
meshes with the pick-
④
②
. Ensure
45