List Of Diagnostics Events With Status And Diagnostics Message For Deactivated; Condensed Status - Siemens SIPART PS2 Operating Instructions Manual

Functions/operations using PROFIBUS PA
9.3 Cyclic data transfer
Bits
7 6 5 4 3 2
0 1 1 1 1 0
1 0 0 0 0 0
1 0 1 0 0 1
1 0 1 0 1 0
1 0 1 1 1 1
9.3.3.6

List of diagnostics events with status and diagnostics message for deactivated

condensed status

A list of diagnostics events with status and diagnostics message for deactivated condensed
status is given in the following table. DIAGNOSTICS_EXTENSION and
DIAGNOSTICS_EXTENSION_2 are physical block parameters.
DIAGNOSTICS_EXTENSION physical block parameter
Byte Bit No.
0 0 1
1 2
2 3
3 4
4 5
5 6
7 ... 21
2 5 22
6 23
7 24
228
1 0
x x Uncertain, process related, no main‐
tenance
x x Good, ok
x x Good, maintenance required
x x Good, maintenance demand
x x Good, function check
Diagnostics events
Run time error of the actuator
The device is not in the "Auto‐
matic mode"
Binary 1 is active (only mes‐
sage)
Action triggered by binary input
1
Binary 2 is active (only mes‐
sage)
Action triggered by binary input
2
Reserved
Limit for alarm A1 exceeded
Limit for alarm A2 exceeded
Error in the device electronic
unit
Name
Profile
Unsicher, Prozess-Störung, kein
Wartungsbedarf
Gut, Ok
Gut, Instandhaltungsbedarf
Good, maintenance requirement
Gut, Funktion überprüfen / Handbe‐
trieb
Hard-coded effect of a diagnostics event
Quality status code
Bad, maintenance requirement DIA_SUPPLY
Uncertain, simulation value
Good, maintenance required
Uncertain, simulation value
Good, maintenance required
Uncertain, simulation value
-
Good, maintenance required
Good, maintenance required
Bad, device error
German
DIAGNOSTICS bit
None
DIA_MAINTENANCE
None
DIA_MAINTENANCE
None
-
DIA_MAINTENANCE
DIA_MAINTENANCE
DIA_MEM_CHKSUM
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
Group
P
-
M1,
M12, M
M12, M
F