Receiver Test - Bosch Security Escort SE2000 Series Training Manual

Security Escort
Figure 8.22: Abort Button to Remove a Device from the Setup Mode
The Central Console also confirms the successful setup with an audible and text message. The
[Abort setup for this MUX point] button disappears and is replaced by [Test on this MUX
point SUCCESSFUL] button. Click this button to conclude the test on this point.
8.3.7

Receiver test

Use this dialog to set up and monitor four receivers, and listen to one receiver transmitting
with its buddy check transmitter. Normally, the function is for engineering evaluation of new
transmitter and receiver designs, but it can be used to test receiver boards and locations in a
working system.
Robert Bosch (SEA) Pte Ltd Training Manual
System menus and dialogs | en 211
2017.08 | V2.18.1.0 | DOC