Walk Test All Zones; Walk Test A Single Zone; Outputs; Output Status - Bosch Solution 6000 User Manual

Zone Name Zn1
Zone 1 Name
Press


3. Use the [] and [] keys to scroll the cursor left and
right across the zone name text. Use the [] and
[] keys to scroll through the different characters
available. To clear all text from the cursor position
to the right, press the [OFF] key.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Inputs > Input Testing >

Walk Test All Zones

This menu allows you to test all zones within an area at the
same time. To successfully walk test each zone, you must
open and close each zone.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [3] + [9] + [0].
The keypad will display a list of areas that are
available to walk test zones.
2. Use the [] and [] keys to select the area that you
want to do walk test, then press [OK] to select.
Alternatively, you can enter the area number, then
press [OK].
The keypad will scroll all zones that you can test.
To test zone Zn1
open then close
Zone 1 Name
Press OK or MENU
To test zone Zn2
open then close
Zone 2 Name
Press OK or MENU
3. Open and close each zone that needs to be tested.
A zone that has been successfully tested will no
longer scroll on the keypad display.
When all zones have been tested, the keypad will
display:
All zones have been
successfully tested
Press OK or MENU
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Bosch Security Systems 12/14 BLCC610U
OK to SAVE
MENU 3-9-0
Inputs > Input Testing >

Walk Test A Single Zone

This menu allows you to select a single zone to be tested
via walk test.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [3] + [9] + [1].
The keypad will display a list of zones that are
available to be tested via walk test.
2. Use the [] and [] keys to select the zone that
you want to walk test, then press [OK] to select.
Alternatively, you can enter the zone number, then
press [OK].
The keypad will display the zone to be tested.
To test zone Zn1
open then close
Zone 1 Name
Press OK or MENU
3. Open and close the zone that needs to be tested.
When the zone has been successfully faulted and
restored, the keypad will display:
Zn1 Zone 1 Name
Test Successful
Press OK or MENU
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.

Outputs

The control panel can have up to a maximum of 37 outputs.
Five outputs are available as standard with an additional 32
available when the optional output expanders are fitted.
Your installer will advise you on the exact makeup and
configuration of your system.
Outputs > Commands >

Output Status

This menu allows you to view the status of each output.
Enter programming mode (PIN + MENU) then,
1. Ensure that the system is turned off.
2. Press [MENU] + [4] + [0] + [0].
The keypad will display a list of outputs that the
status may be viewed.
3. Using the [] and [] keys, highlight the output
that you want to view the status information, then
press [OK] to select. Alternatively, you can enter the
output number and then press [OK].
The keypad will display the following when the
output is off and OK:
Solution 6000 User Guide
MENU 3-9-1
MENU 4-0-0
25