Bosch Security Escort SE2000 Series Training Manual page 208

208 en | System menus and dialogs
Figure 8.21: Receiver Configuration Dialog
[Put this receiver in setup
mode]
Ambient value
Auto Advance
RF micro revision
2017.08 | V2.18.1.0 | DOC
This button initiates the setup process by causing both the
red and green LED of the selected receiver to light up. The
red and green LED will be flashing. On the Central Console,
this button changes the [Abort setup for this MUX Point]
button to be able to proceed to the next device in the event
that one receiver is not set up properly.
The Ambient value, shown above Auto Advance, shows the
current ambient level at the receiver. To get an updated
ambient reading, select the point and click the [Transmit]
button followed by the [Ambient] button.
If this checkbox is checked, the Central Console
automatically selects the receiver with the next higher point
address.
The receiver's RF micro revision level is shown below Auto
Advance. To get an updated reading, click the [Revision]
button.
Training Manual
Security Escort
Robert Bosch (SEA) Pte Ltd