Bosch Security Escort SE2000 Series Training Manual page 107

Security Escort
Figure 7.3: Receiver Configuration Dialog
Select the desired transponder. Click on the [?] button next to the point number. A bus and
point grid will appear showing the programmed receivers. Click on the lowest point number
button. If the first receiver is point 0, click on the [0] button, or if the first receiver is point 1,
click on the [1] button. The point number will be automatically entered. Click the [Put this
receiver in setup mode] button. The red and green LEDs will light for the selected receiver on
the selected transponder.
Robert Bosch (SEA) Pte Ltd
Troubleshooting transponders, points, receivers, and alert units | en 107
Training Manual 2017.08 | V2.18.1.0 | DOC