Bosch Security Escort SE2000 Series Training Manual page 71

Security Escort
Default Master computer
Default Slave computer
Workstation computer
Remote computer
Emergency answer only
Master computer answers
Slave computer answers
Direct connect port
Answering machine override
Pulse dial
Answer on ring
Dialing prefix
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
This computer is either the only computer in the system, or
on startup, this computer defaults to the Master computer in
a live Security Escort System.
On startup, this computer defaults to the slave computer in
a live Security Escort System.
This computer is used in a live Security Escort System for all
operator functions. It cannot control the system like the
Master and Slave computers.
This computer is not in a live Security Escort System. It is
used only for remote access. For this setting to be enabled,
all transponder communication ports and the network port
must be set to "None".
Allows the Master computer to answer a remote access only
after 10 rings. If the Master does not answer, the Slave
answers after 12 rings.
Allows the Master computer to answer a remote access after
the programmed number of rings. If the Master does not
answer, the Slave will answer after the programmed number
of rings plus 2.
Allows the Slave computer to answer a remote access after
the programmed number of rings. If the Slave does not
answer, the Master answers after the programmed number
of rings plus 2. Generally, it is better to have the Master
computer answer remote access calls.
The modem port is not connected to a modem. This setting
will allow a direct connection to another computer. This
additional computer will not display alarms, but otherwise
will behave like a Slave computer.
If checked, an answering machine is connected to this
phone line. If the answering machine answers a remote
access call, hang up and redial. When another call is
received within 1 min. of the last ring of a previous call, the
Security Escort System will answer on the first ring,
overriding the answering machine.
If checked, use pulse dial on all outgoing calls. Otherwise,
tone dialing (default) is used.
Program the number of rings on which to answer. If there is
an answering machine on this phone line, set the number of
rings to at least 2 greater than the number of rings the
answering machine answers. Also check the Answering
Machine Override checkbox.
On outgoing calls, enter the dialing prefix, if any.
Training Manual
71
2017.08 | V2.18.1.0 | DOC