Security Escort
–
Operation notes
–
–
–
–
4.9
ProxLink setup
Robert Bosch (SEA) Pte Ltd
After wiring the system, replace the cover and power up the unit.
Each transponder must have its own address.
For the Security Escort ® system to maintain operation, the SE485 must be powered at all
times. Use the 9 V adaptor provided plugged into an uninterrupted power supply (UPS).
The SE485 may also be powered from the transponder's 9 V output connected to the 9 V
DC input wiring connectors.
Up to four SE485s can be included in an installation. If using multiple SE485s, use the
connector cable provided.
Training Manual
System wiring | en
53
2017.08 | V2.18.1.0 | DOC