Central Console, Computer Setup And Programming; Transponder Comm Port Setup; Remote Comm Port Setup Dialog - Bosch Security Escort SE2000 Series Training Manual

68 en | Central Console, computer setup and programming
6

Central Console, computer setup and programming

6.1

Transponder comm port setup

Go to menu Setup > Transponder comm port setup... This dialog connects the communication
port indexes set for each transponder in the Transponder Database to the physical
communication ports on the computer.
Figure 6.1: Transponder Comm Port Setup dialog
COM
Carrier Det
No CTS
Mon Power
6.2

Remote comm port setup dialog

This dialog connects the network, modem and system serial ports to the physical
communication ports on the computer and sets their baud rate.
2017.08 | V2.18.1.0 | DOC
The actual physical communication port over which
communications to the transponder will be carried.
If checked, verify that the communications port is not in
use before communicating. Only to be used on half duplex
links where Carrier Detect indicates that the link is in use.
This setting is normally unchecked and rarely used.
If checked, do not monitor the Clear to Send before
communicating. This setting is normally checked.
If checked, monitor the Ring Indicator pin to indicate a
remote power supply used on this communication link has
not failed. This setting is normally unchecked.
Training Manual
Security Escort
Robert Bosch (SEA) Pte Ltd