Table of Contents
Advertisement
Table 3: Start here (continued)
If you are here for this reason . . .
Fibre Channel Port 0 or Port 1 LED on back of drive is
solid green.
Power LED at back of drive is OFF (see Figure 4 on
page 31 for LED location).
Drive does not power ON.
AC or DC LEDs on power supply indicate an error.
Power supply LEDs do not light.
Library LED at back of drive is OFF (see Figure 4 on
page 31 for LED location).
Front panel (bezel) problems such as a blank 8-
character display or no power LED on back of drive
Stuck tape or cartridge
Replace a leader pin
Clean messages on service panel or reported to the
host, or you suspect that the drive must be cleaned
Drive rejects cleaning cartridge, and posts "Clean
Required" message
Excessive temporary errors reported to the host
Complete this action . . .
Fibre Channel connections are detecting light, but no
data is being transferred.
1. Wrap tools are installed. Remove the wrap tools,
and connect the Fibre Channel cables.
2. Drive is offline to the host. Use the service panel to
set the drive online, then reset the drive. See
"Services menu" on page 97.
3. If this condition continues, go to "Fibre Channel
problem determination" on page 237.
Go to "Power problems MAP" on page 193.
Go to "Power problems MAP" on page 193.
Go to "Power problems MAP" on page 193.
Go to "Power problems MAP" on page 193.
The normal condition if the RS-422 or SDLC port is not
used.
Go to FID entry point on page "FID entry point" on
page 6: FID AF.
Go to "Manual cartridge removal" on page 195.
Customer responsibility (see 3592 Drive Operator
Guide)
Insert the cleaning cartridge in the drive; cleaning is
completed automatically.
Note: If an excessive number of clean messages
appeared (that is, the additional message Clean
Required appeared on the service panel), go to
"Excessive Clean messages" on page 183.
Because the cleaning cartridge reached its end of life,
a cleaning cycle cannot be allowed. Ask the customer
to replace the cleaning cartridge. Refer to the 3592
Drive Operator Guide.
1. Review the temporary error log. See "CE Temp Error
Log menu" on page 137. Alternative error logs are
the FID FE error log and the FID FF error log. See
"CE Logs menu (CE Offline Mode)" on page 133 for
a description of the error logs.
2. Go to Chapter 3, "Messages," on page 39 for your
system.
a. Review "Message codes" on page 45.
b. Review "Sense Keys, ASC, and ASCQ
information" on page 47.
3. Ensure that the Force Error Log option is OFF. Go
to "CE Config/Install menu" on page 118.
Start 3
Advertisement
Table of Contents
