Clear Storage Subsystem Event Log; Clear Storage Subsystem Firmware Pending Area; Clear Storage Subsystem Recovery Mode; Configure Automatic Support Bundle Collection - IBM System Storage DS3000 Programming Manual

Clear Storage Subsystem Event Log

This command clears the Event Log in the storage subsystem by deleting the data in the Event Log
buffer.
Attention:
Possible damage to the storage subsystem configuration – As soon as you run this command, the
existing Event Log in the storage subsystem is deleted.
Syntax
clear storageSubsystem eventLog
Parameters
None.

Clear Storage Subsystem Firmware Pending Area

This command deletes a firmware image or NVSRAM values that you have previously downloaded from
the pending area buffer.
Attention:
Possible damage to the storage subsystem configuration – As soon as you run this command, the
contents of the existing pending area in the storage subsystem are deleted.
Syntax
clear storageSubsystem firmwarePendingArea
Parameters
None.

Clear Storage Subsystem Recovery Mode

This command forces a storage subsystem to exit recovery mode.
Syntax
clear storageSubsystem recoveryMode
Notes
Recovery mode is entered during start-of-day operations when the system configuration is cleared and a
valid on board backup is available. This mode is exited by either restoring the system configuration from
a backup location, or by clearing the existing on board backups. While recovery mode is in force, a needs
attention condition is raised and the Recovery Guru will be available from the user interface. However,
the system configuration will be empty during recovery mode.

Configure Automatic Support Bundle Collection

This command enables or disables the automatic collection of support bundles on one or more storage
subsystems when a critical MEL event is detected.
3-54
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide