IBM 3592 Maintenance Information page 136

Table 74: Load FMR Tape menu (continued)
Function
Note:
1. Supplemental Message Line 1: Use FMR tape
2. Supplemental Message Line 2:
• Expected FMR tape
• Tape not at load pt
• Tape write prot'd
Cancel
Allows the CE to return to the CE Options menu.
Process Loaded Tape
If an FMR tape is loaded and at ready point, a new menu might display, depending on the previous
menu.
Unload Drive
Allows the CE to unload the cartridge from the drive.
Note: See messages that appear on Supplemental Message Line 2:.
• Expected FMR tape - Scratch tape was loaded.
• Tape not at load pt - Not at ready point, wait for tape cartridge to finish loading.
• Tape write prot'd - If the service panel shows the file-protected icon, the tape cartridge is either
physically write-protected or the customer used a command to logically write-protect the tape
cartridge.
CE Select Level menu
Table 75 on page 116 shows the CE Select menu items. This menu displays when the device loads an
FMR tape (cartridge). The device reads all the EC levels, and displays them on this menu. The invalid EC
levels are displayed in a lighter font. The message lines display the EC level that runs in the device. The
ECs are displayed in the same order as they appear on tape. The CE chooses which EC level to load into
the device.
To activate the drive microcode after you load it, you must complete a power-on reset or a CE reset.
Operational Note: If you insert the FMR cartridge, and the EC level of the microcode is not on the
cartridge, the microcode is copied automatically from the drive to the cartridge.
Table 75: CE Select Level menu
Function
Cancel
EC=aaaaaaa LL=bbbb
EC=ccccccc LL=dddd
EC=eeeeeee LL=ffff
Note:
1. Supplemental Message Line 1: Current EC Level:
2. Supplemental Message Line 2: <EC Level q>
116 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
Next menu
Next menu
"CE Options menu" on page 107
"Status menus" on page 109
"Status menus" on page 109
"Status menus" on page 109