Table of Contents
Advertisement
Post-installation reporting and activities
Follow this procedure after the drive is installed and tested, and the "End of call" on page 185 is
completed.
1. Record the drive serial number (from the label) into the machine history log. See "Microcode EC level
history log" on page 205.
Note: Record this serial number for use when nonvolatile storage is restored. It might be required by
certain repair procedures.
2. Record the installed microcode level into the machine history log. See "Microcode EC level history log"
on page 205.
3. Ensure that the "Fibre Channel worldwide names history log" on page 206 is filled out.
4. Save the tools and cartridges (and possibly the drive packaging materials) in a safe place for later use.
5. Store the service panel in the holder.
6. Report the installation as complete, using the local branch office procedure.
7. After the installation is successfully completed, notify the customer that the drive is now available for
use.
Removing the drive from service
Notes:
• If your host system has software aids for system upgrades, installations, or relocations, run that
software and follow the instructions that they provide.
• Use this procedure only if you are removing a drive from service and not returning it to service currently.
Follow this procedure to remove a 3592 drive from service. Consider storing the removed drive in an
empty shipping carton or relocation kit package.
1. Before you proceed, check the following -
a. Ensure that the drive is unloaded and that the tape cartridge is removed from the drive.
b. Notify the system operator that you are removing the 3592 and that it is not available, then vary the
drive offline.
2. Remove the drive: "FID 85: Drive canister" on page 252
3. The 3592 drive is now removed from service. If you are transporting or storing the 3592 drive for an
extended period, see "Relocating or storing the drive" on page 180.
Relocating or storing the drive
Follow this procedure to relocate or store a 3592 drive.
Notes:
• Before this procedure begins, ensure that you complete "Removing the drive from service" on page 180.
• Ensure that you have an empty shipping carton or a relocation kit available before you begin this
procedure if you plan to transport the drive some distance from the point of removal to relocate it or if
you plan to store the drive. See Chapter 9, "Parts catalog information," on page 259 beginning for the
relocation kit part number.
1. Move the drive to the new location.
--OR--
2. If you are not reinstalling the drive, place it in the shipping carton. See "Repacking instructions" on
page 181.
180 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
Advertisement
Table of Contents
