Alter Serial No - Ce Vpd Data Menu; Alter Serial No - Ce Save Data? Menu - IBM 3592 Maintenance Information

Setting WW names
Note:
1. If you alter any name, you must save or alter all the names. For example, if you alter the Node 0 Name
only, you must at least save Node 1, Port 0 and Port 1.
2. Refer to "Supplemental Messages" in Table 44 on page 79 for fibre- addressing information.
1. Ensure that the drive is offline.
2. At the Options Display screen, press Change Mode . Select CE Offline Mode > Config/Install >
Drv Options.
Note: The drive Serial No, Node 0 Name/Node 1 Name, Port 0 Name, and Port 1 Name must be
recorded. If not, see "Displaying WW names" on page 207, and enter the data in Table 145 on page
207, as necessary.
3. At the CE Drv Options menu, select Drv Serial No.
4. Select Alter Serial No. Increment each serial number digit, as necessary, to reflect the recorded
serial number.
Table 148: Alter Serial No - CE VPD Data menu
CE VPD Data
►0
1
0
0
1
1
SAVE AND CONTINUE
5. Select SAVE AND CONTINUE, then press Enter. This action causes the CE Save Data? menu to
display.
Table 149: Alter Serial No - CE Save Data? menu
CE SAVE DATA?
►CANCEL
YES
NO
6. Select YES, then press Enter to store the data into VPD memory and return you to the CE DRV Ser No
menu.
7. Select Cancel, as necessary to return to the CE Config/Install menu.
8. Select Fibre Options, then select Set Node 0 Name.
9. Get the Node 0 Name from Table 145 on page 207 and enter the last 6 digits into VPD memory, as
shown in Table 150 on page 208. Increment the Node 0 Name digit positions to reflect the recorded
Node 0 name.
Table 150: CE Set Node 0 Name menu
SET NODE 0 NAME
208 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
▲
▲
J1A-F
SEQUENCE NUMBER
J1A-F
Supplemental Message section contents depend on
the data that is stored.
Serial
Sequence Number
Node 0/1
Noden FC WWID
Port 0/1
Portn FC WWID
J1A-F