IBM 3592 Maintenance Information page 139

Drv Options...
Allows the CE to set items from "CE Drv Options menu" on page 119.
VPD Options...
This option is not available for Rack Mount drives.
Fibre Options...
Allows the CE to view the drive node name and port names. See "Fibre Channel worldwide names
history log" on page 206.
Force Er Log On/Off
Use this only when directed by your next level of support. - Allows the CE to turn error-logging ON.
When set to ON, deferred-check conditions are reported to the host. Therefore, temporary errors are
reported in the sense data. The default is Off.
CE Drv Options menu
Table 79 on page 119 shows the CE DRV (Drive) Options menu items.
This menu allows the CE to set specific drive information that is needed during the installation of the
drive. The default values appear in Table 79 on page 119 in a bold font.
Note: The CE DRV (Drive) Options menu displays the status. For example, if the HSARS Enabled/Disabled
option says 'HSARS Disabled,' that means that HSARS is disabled. To enable HSARS, select the option.
The option changes to show the new status, 'HSARS Enabled.'
Table 79: CE DRV (Drive) Options menu
Function
Cancel
Drv Serial No...
Drv Features...
Drv Encryption
Clean Mounts
Clean Usage
HSARS Enabled/Disabled
VSARS Enabled/Disabled
SIM Sev Filt On/Off
MIM Sev Filt On/Off
Num Repeat SIMs
Set Sense ID
Disable CU Mode
Note:
1. Supplemental Message Line 1: When done, select
2. Supplemental Message Line 2: CANCEL option
3. Highlighted functions, such as Enabled, are the default values.
Cancel
Causes the "CE Config/Install menu" on page 118 to display. If any of the VPD options are updated,
the CE WAIT message might be displayed momentarily while the flash memory is being rewritten.
Next menu
"CE Config/Install menu" on page 118
"CE DRV Ser No menu (CE Offline Mode)" on page 121
"CE DRV Features menu" on page 150
"DRV Encryption menu" on page 121
CE Display/Alter (not shown)
CE Display/Alter (not shown)
-
-
-
-
"CE VPD Data menu" on page 127
-
-
Virtual Operator panel 119