Diagnostics Device Errors - Emerson 5301HxxxxxxxxxxxxxxZZ Series Reference Manual

Reference Manual
00809-0100-4530
F.4

Diagnostics device errors

In addition to the BLOCK_ERR and XD_ERROR parameters, more detailed information on
the measurement status can be obtained via DIAGN_DEV_ALERT.
potential errors and the possible corrective actions for the given values. The corrective
actions are in order of increasing system level compromises. The first step should always
be to reset the gauge and then if the error persists, try the steps in
the first corrective action and then try the second.
Table F-17: Device Errors Diagnostics
Bit Number Value of DIAGN_DEV_ALERT
0
0 0x00000001
1 0x00000002
2 0x00000004
3 0x00000008
4 0x00000010
5 0x00000020
6 0x00000040
7 0x00000080
8 0x00000100
9 0x00000200
10 0x00000400
11 0x00000800
12 0x00001000
13 0x00002000
14 0x00004000
15 0x00008000
16 0x00010000
Reference Manual
Description
No alarm active
Reserved
FF card to gauge comm fault
Level measurement failure
Temperature measurement
failure
Volume measurement failure
Database Error
HW Error
Microwave Unit Error
Configuration Error
SW Error
Invalid Strap Table
Internal Temp Warning
Database Warning
HW Warning
Microwave Unit Warning
Configuration Warning
SW Warning
Level Transducer Block
April 2019
Table F-17 lists the
Table F-17. Start with
Corrective action
Replace gauge
Verify device installation and
configuration
Check ambient temperature. If
ambient temperature ok
replace the device.
Check volume configuration
Load default database to the
device and reconfigure the
device
Replace device
Replace device
Load default database to the
device and reconfigure the
device
Replace device
Check the Strapping Table
configuration
Check ambient temperature at
installation site
Check the device configuration
Check device installation and
configuration
Check device installation and
configuration
Check the device configuration
Check device installation and
configuration
435